|
WELD
For most applications, the DMI series is used to make a
butt weld. Depending on the process line requirement,
the weld can be used as a transport weld, being removed
at the exit end of the line, or it can be used for coil
buildup. Butt welds created using this machine are usually
nearly as strong as the parent material.
PRODUCT RANGE
These machines can shear and butt weld material ranging
from about 0.060" (1.50mm) up to about 1" (25mm)
thick, and as wide as necessary. Recent machines have
been used for strip up to 86" (2,150mm) wide. Any
weldable material can be used on these machines. Since
the coil ends must be flat for proper operation of these
machines, the use of a flattener is normally recommended.
STANDARD EQUIPMENT
Most DMI and DMA's are equipped with:
• Entry and Exit Side Guides
• Camber Compensation
• Entry and Exit Weld Clamps with 6" (150mm) vertical opening
• Gap Control
• Automatic Welding Carriage with DC drive and Welding Torch(es)
• Indexing Plate
• Single Cut - Down Cut Shear
• Backup Bar
• Entry and Exit Passline Rolls
• Operator Station and Control Panel
• Hydraulic Power Unit
|
