|
|
WELD
The weld created by the QM series is an overlap resistance
weld. The two coil ends are slightly overlapped and
the weld wheels, one on the top and one on the bottom,
roll across the overlapped ends. Usually, a steel roll
planisher, again one on the top and one on the bottom,
follows the weld wheels, and the result is a very fast,
flat, and strong weld. Welds created using this machine
are usually nearly as strong as the parent material.
PRODUCT RANGE
The QMT and QMM can shear, weld, and planish material ranging
from about 0.004" (0.1mm) up to about 0.135" (3.5mm)
thick, and as wide as necessary. Recent machines have
been used for strip up to 76" (1,900mm) wide. Any weldable
material can be used on these machines.
STANDARD EQUPMENT
Most QM series machines are equipped with:
. Entry and Exit Side Guides
. Camber Compensation
. Entry and Exit Weld Clamps with 5" (125mm) vertical opening
. Positive Overlap Control
. "C" Frame which includes:
o Welding Wheels, o Planish Wheels, o Double Cut Shear
o Scrap Conveyor, o Weld Equipment
. AC Vector variable drive For "C" Frame
. Entry and Exit Passline Rolls
. Weld Wheel Reconditioner
. Operator Station and Control Panel
. Pneumatic Operation
|
